Sorry my bad english.
Before use Axisvm modules to design, i made some researchs and then i decided that My national codes NBR is very similar to Eurocode, then I use this module to design, and in some cases I make check with external spreadsheet ( in a near future I will conect this spreadsheet straight into axisvm).
But all of this only for welded and Hot rolled members.
I see that axisvm dont design cold formed, then I do this in an external spreadsheet, but, I dont know eurocode totaly, and when i create some members made of plates (without radius) and check this members with cold formed, axisvm can design and show results like hot rolled.
Why exisvm can design if i checked with cold rolled?
This results are valid in eurocode if I create the member with effective dimensions?
I can use this to aproximate design and finally check with external spreadsheet?
I made a lot of basic experiences with another softwares with Nbr cold rolled included and results are very similar.
This week in my free time i will make some advanced analisys with bending.
All abot cold formed is new to me, and im doing a lot of researchs with strip methods, direct resistance methods.
Any scientific research or basic point of view can help me a lot.